floating point division by zero
Posted: Tue 28 Oct , 2008 13:02 pm
NOVAMILL ATC Circa 2002
Customer recently downloaded VR CNC Miling V. 2.31. Software and manufacturing runs fine. One small problem is 1) run a part it works perfect. 2) run the 3-D simulation it runs perfect. 3) try to have the 3-D simulation run at the same time the part is running get an error message dialog box: floating point division by zero. Customer has turned down the hardware acceleration but message still pops up.
The message does not affect or stop manufacturing. It just becomes annoying because when you turn it off it comes back on several times during the course of the program.
Any ideas?
Customer recently downloaded VR CNC Miling V. 2.31. Software and manufacturing runs fine. One small problem is 1) run a part it works perfect. 2) run the 3-D simulation it runs perfect. 3) try to have the 3-D simulation run at the same time the part is running get an error message dialog box: floating point division by zero. Customer has turned down the hardware acceleration but message still pops up.
The message does not affect or stop manufacturing. It just becomes annoying because when you turn it off it comes back on several times during the course of the program.
Any ideas?