VR 5 vs spindle Probe

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
malutki69
CNC Apprentice
CNC Apprentice
Posts: 46
Joined: Sat 10 May , 2014 22:35 pm

VR 5 vs spindle Probe

Post by malutki69 » Sun 05 Feb , 2017 12:30 pm

Hello is it possible connection spindle probe on Denford Triac PC whit USB control card?.... if so, how to connect, and where insert the macro. Regards

MadeForThat
CNC Apprentice
CNC Apprentice
Posts: 80
Joined: Mon 20 May , 2019 15:15 pm
Hardware/Software: Micromill 2000:
Nextstep-4 axis
Novaturn ns:
denstep card (from swap)-atc

Re: VR 5 vs spindle Probe

Post by MadeForThat » Wed 01 Apr , 2020 21:22 pm

Dug up an old post, but i'm interested. I would like to be able to automatically probe tool heights after a tool change. Has this been attempted by denford?

Post Reply