Manual Tool Change and Tool Offsets

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Steve, Mr Magoo, Martin, bradders

Post Reply
Posts: 4
Joined: Mon 17 Sep , 2018 17:54 pm
Hardware/Software: Windoze 10

Manual Tool Change and Tool Offsets

Post by LozHarropLures » Fri 15 Mar , 2019 0:08 am


If I have four tools in Quick Change holders and set the Tool Offsets for tools 2,3,4 in the editor are these offsets active when I load and run a .vnc file?

Hope that makes sense.


Post Reply