Page 1 of 1
BobCAD Which Post to use with VR Milling VR Turning
Posted: Mon 30 Jan , 2012 10:55 am
by JSKRABA
I am considering using BobCAD with VR Milling 2.3 and VR Turning
Does any one know which of the many posts that BobCAD/Cam has is best?
Does any one from Denford Support have an idea how I might know, is there a spec I could use.
Re: BobCAD Which Post to use with VR Milling VR Turning
Posted: Mon 30 Jan , 2012 11:40 am
by Denford Admin
This post should help if you need to create your own.
Start with a basic Fanuc 0M or 0T post and try not to use Cycles (ie, have Bobcad expand cycles into G01,G02 and G03's)
Re: BobCAD Which Post to use with VR Milling VR Turning
Posted: Fri 03 Feb , 2012 20:35 pm
by Croy
if you post a request on BobCad site they will respond and answer you.
Re: BobCAD Which Post to use with VR Milling VR Turning
Posted: Mon 06 Feb , 2012 10:39 am
by Denford Admin
Denford Admin wrote:This post should help if you need to create your own.
Start with a basic Fanuc 0M or 0T post and try not to use Cycles (ie, have Bobcad expand cycles into G01,G02 and G03's)
Sotty, I meant to link to this post:
viewtopic.php?f=16&t=1370