AlphaCAM post processor for Denford VR Milling

Anything to do with configuring CAM systems and Post Processors to run on different CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

AlphaCAM post processor for Denford VR Milling

Post by Denford Admin » Wed 07 Apr , 2010 10:44 am

This is a post file for AlphaCAM that we made a few small changes to for a customer with V5 Milling and a Triac Upgrade machine.

Just find where all the other .amp files are located (MPOSTS.ALP) , unzip this file and put it in with the others.
Attachments
DenfordV5.amp.zip
(6 KiB) Downloaded 1624 times

Post Reply