Page 1 of 1

FEATURECAM POST PROCESSOR REQUIRED

Posted: Wed 12 Nov , 2008 23:52 pm
by -=PAB=-
ANYONE WHO HAS A GOOD WORKING POST PROCESSOR FOR DELCAM FEATURECAM I WOULD BE GRATEFUL IF THEY COULD POST IT.

MANY THANKS.

Posted: Thu 13 Nov , 2008 18:58 pm
by Lone_Ranger
.

For what machine???

Mill?? Turn??

There are a lot of Post Processors in FeatureCAM !!!!!!

If you are having problems with yours then it may just need editing, I don`t know of any Post Processors that are 100% spot on, most are close to the exact machine you have but usually need a "tweak" or two!!

Delcam will probably do one for your machine anyway if you send them some sample code from the machine, most of the CADCAM software companies will do it for free but to honest I don`t know if Delcam do it free or not!!

:mrgreen: :mrgreen: :mrgreen: :mrgreen: :mrgreen: