Micromill electrical diagrams ?

Manuals, Documents and Software downloads related to Denford CNC Machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
A.PENNOCK
Posts: 13
Joined: Wed 14 Feb , 2007 19:25 pm

Micromill electrical diagrams ?

Post by A.PENNOCK » Sun 06 Dec , 2009 22:08 pm

Has anyone out there got a wiring diagram for the micromill please?

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Micromill

Post by Steve » Sun 06 Dec , 2009 22:31 pm

What is the age of the machine?

Where are you located?

Do you have a problem with it?

A.PENNOCK
Posts: 13
Joined: Wed 14 Feb , 2007 19:25 pm

Re: Micromill

Post by A.PENNOCK » Sun 06 Dec , 2009 22:46 pm

Unshure of its age but the main circit board was produced by:
OPTIMISED CONTROL LIMITED
BRISTOL
D771 ISSUE 2
4202

The previouse owner decided to take all the wires out to convert it to mac i have identified the stepper motors but i want to get the speed controll working i am in county Cleveland

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Micromill

Post by Steve » Mon 07 Dec , 2009 9:48 am

Could you take a photo of the electrical panel?

A.PENNOCK
Posts: 13
Joined: Wed 14 Feb , 2007 19:25 pm

Re: Micromill

Post by A.PENNOCK » Mon 07 Dec , 2009 21:06 pm

DSCF0650.JPG
DSCF0650.JPG (76.56 KiB) Viewed 13297 times

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Micromill

Post by Denford Admin » Tue 08 Dec , 2009 10:16 am

Hopefully these drawings will give you enough info...
viewtopic.php?f=15&t=2495

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Micromill

Post by Steve » Tue 08 Dec , 2009 11:23 am

Hi,

The board you have is earlier than anything I have drawings for.

I suspect it would be a very basic circuit.

I attach a diagram for a smart step which was the following generation machine.
Attachments
SMARTSTEP SCHEMATIC.pdf
(112.34 KiB) Downloaded 1115 times

Post Reply