Small Pot with Screw Top Lid

Read what other Denford users are doing with their machines and software.
Educational resources, ideas and courseware.
If you have a Denford related success story, please tell us about it here.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Ronin
Posts: 3
Joined: Tue 08 Jan , 2013 15:32 pm
Hardware/Software: Denford Range
Location: Brighouse

Small Pot with Screw Top Lid

Post by Ronin » Fri 11 Jan , 2013 10:17 am

This is a program for the Turn 270 to produce a small pot with screw top lid.
For this I used a 50mm long, 25mm diameter aluminium bar.
Attachments
Screw Top Pot.png
Picture of the pots
Screw Top Pot.png (1.02 MiB) Viewed 8467 times
18mm fine thread fixture_male.fnl
This fixture enables you to face off the pot and clean up the pip left from parting off.
(2.9 KiB) Downloaded 841 times
18mm fine thread fixture_female.fnl
This fixture enables you to face off the lid and clean up the pip left from parting off.
(2.37 KiB) Downloaded 955 times
NewLid_Pot.fnl
This file contains both lid and pot together and will turn both parts in one program.
(6.5 KiB) Downloaded 868 times
NewPot.fnl
The pot
(3.09 KiB) Downloaded 821 times
NewLid.fnl
The lid
(3.45 KiB) Downloaded 841 times

Post Reply