Denford Mirac for sale as need the space

Anything to do with buying, selling or sourcing Denford machines, spares or software - please use sensibly!

Moderators: Martin, Steve, Mr Magoo

Post Reply
SAW2020
Posts: 8
Joined: Mon 27 Jan , 2020 11:35 am
Hardware/Software: Triac Fanuc 21i, Mirac PC & Triac PC

Denford Mirac for sale as need the space

Post by SAW2020 » Thu 12 Nov , 2020 19:16 pm

I have a very nice Mirac PC that i'm looking to sell as I need the space for another machine :D

all the hard work done, its wiring (tidy) has been converted to run either Mach3 or UCCNC - just needs the ATC building back up as it was full of solid grease.

Software would need to be configured for whichever control you wanted to use but options for either are there.

UC300ETH-MAX Controller from CNCroom.com
Two new inverters, one for spindle & one for tool post
New British spindle encoder 360ppm
Pneumatic Chuck & Pneumatic guards open/close of buttons now rather than M codes
Its hardly done any work and inside the machine is in very good condition - outside it has some wear and marks but i was just going to give it a freshen up.
all wiring has been traced from original diagrams and all matched by original numbers (tags still present) where possible so its easy to see what's going on

drop me a message with you email and I'll fire some pictures across or ebay link below

looking for £2000 or offers

http://rover.ebay.com/rover/1/710-53481 ... olid=11111

Post Reply