Please can anyone assist?
I have obtained an ex school Viceroy lathe. model TDS 1/1G/S/L serial number 21560
There is a lot of play (backlash) on the cross slide due to wear on the nut.
Please has anyone or does anyone know where I can obtain a spare or have a new nut made?
The lathe is in quite good order except for this and I wish to use it to for model engineering. Many thanks
Viceroy metric lathe ex school)
Moderators: Martin, Steve, Mr Magoo
-
- CNC Guru
- Posts: 613
- Joined: Tue 29 Apr , 2014 18:38 pm
- Hardware/Software: Starturn 5 (sort of running, I will get this done!)
Lathe cam designer V1.11
Quickturn 2D Design
FANUC offline and online programs.
Microrouter Pro NS V5 (microstep)
VR2 and VR5
Boxford VMC260
Techsoft 2d Design tools V1 > V2
ProDesktop
Fusion 360
Deskproto
Re: Viceroy metric lathe ex school)
There was a guy on eBay who was making nuts for various lathes.
Pete
Pete
Re: Viceroy metric lathe ex school)
The cross slide screw is 1/2" diameter 2.5mm pitch LH modified square section thread which means that it is almost square with just 5 degrees flank angle each side. You'd have to either grind a tool to turn a nut or make a tap to suit.
Another option is to make a nut from delrin, following the instructions here:
viewtopic.php?f=50&t=3727
Another option is to make a nut from delrin, following the instructions here:
viewtopic.php?f=50&t=3727