I converted a Micromill to parallel port control and no longer need the RS-232 cable that used to go from the case to the Balfor motion control top board inside the unit.
Photos of the cable can be found at the bottom of this post:
https://www.summet.com/blog/2016/03/26/ ... -complete/
If you want it, I'll mail it to you for the cost of postage. (Say $5 in the USA?) If nobody claims it within a month or so, I'll probably trash it.
Jay
Free RS-232 cable for Micromill / Lathe / Balfor top board
Moderators: Martin, Steve, Mr Magoo
Re: Free RS-232 cable for Micromill / Lathe / Balfor top bo
Hi Jay, I don't need the cable which I'm sure is gone by now, but I am interested in your software, is it the DOS software? and if so is it possible to get a copy of it