Free RS-232 cable for Micromill / Lathe / Balfor top board

Anything to do with buying, selling or sourcing Denford machines, spares or software - please use sensibly!

Moderators: Martin, Steve, Mr Magoo

Post Reply
summetj
Posts: 13
Joined: Sat 09 Jan , 2016 14:25 pm
Hardware/Software: ScanTek 2000 ScanMill (Micromill 2000)
ScanTek 2000 ScanTurn (Microturn 2000)

Free RS-232 cable for Micromill / Lathe / Balfor top board

Post by summetj » Sat 26 Mar , 2016 18:50 pm

I converted a Micromill to parallel port control and no longer need the RS-232 cable that used to go from the case to the Balfor motion control top board inside the unit.

Photos of the cable can be found at the bottom of this post:
https://www.summet.com/blog/2016/03/26/ ... -complete/

If you want it, I'll mail it to you for the cost of postage. (Say $5 in the USA?) If nobody claims it within a month or so, I'll probably trash it.

Jay

jim3195
Posts: 3
Joined: Sun 09 Oct , 2016 10:07 am
Hardware/Software: MicroRouter

Re: Free RS-232 cable for Micromill / Lathe / Balfor top bo

Post by jim3195 » Wed 12 Oct , 2016 9:50 am

Hi Jay, I don't need the cable which I'm sure is gone by now, but I am interested in your software, is it the DOS software? and if so is it possible to get a copy of it

Post Reply