hi
I am looking for an indexing tool post for a denford orac , I know this is a long shot or does anybody know anything else that with a little bit of modification would fit the orac a 6 or 8 station toolpost would do
thanks for looking
robert
wanted indexing toolpost
Moderators: Martin, Steve, Mr Magoo
wanted indexing toolpost
Denford Orac cnc Lathe
Denford Easiturn Lathe with a Fagor 8020 TG control system also fitted with a biffaldi 6 station tool changer
Denford Easiturn Lathe with a Fagor 8020 TG control system also fitted with a biffaldi 6 station tool changer
Re: wanted indexing toolpost
Hi Robert
The tool turret from Emco 5 series will be OK, just needs a spacer to bring to centre height,
takes 3x1/2" square tools and has 3x3/8" round sockets, std turret uses a 12v DC motor to rotate with reversed polarity 6v DC used to lock in position.
Emgee
The tool turret from Emco 5 series will be OK, just needs a spacer to bring to centre height,
takes 3x1/2" square tools and has 3x3/8" round sockets, std turret uses a 12v DC motor to rotate with reversed polarity 6v DC used to lock in position.
Emgee
Re: wanted indexing toolpost
thanks emgee , I will keep a look out for an emco tool changer as well
all the best
robert
all the best
robert
Denford Orac cnc Lathe
Denford Easiturn Lathe with a Fagor 8020 TG control system also fitted with a biffaldi 6 station tool changer
Denford Easiturn Lathe with a Fagor 8020 TG control system also fitted with a biffaldi 6 station tool changer