I have a Denford Orac for sale. The person I bought it from told me it came from a school andf had been converted to Mach3.
It has had a new board with controller card installed and stepper motor drvers but when you run Mach3 the axis don't move.
It has the manual tool post and looks like it has been cutting wood.
It has a variable speed controller fitted and the spindle does start in forward and reverse.
It has some surface rust it which should clean off OK.
It comes with the computer with Mach3 installed.
Don't think it would take much to get it going. Might just be a broken connection or something.
I have too many projects to sort it out and am looking for about £750 for it.
I also have a Denford Mirac lathe in excellent condition and a Denford Triac mill with 8 station toolchanger, BT30 spindle and PC controilled with VR software.
All machine are for sale and all machines are single phase (240 volt)
Any questions phone Bob on 07854500851
Denford Orac for sale
Moderators: Martin, Steve, Mr Magoo
-
- CNC Apprentice
- Posts: 66
- Joined: Mon 19 Apr , 2010 9:18 am
- Hardware/Software: two Triacs one Orac.
- Location: Ellada
Re: Denford Orac for sale
I am trying to reach you through the phone number that i see here via Viber but i am getting the message ...no network
We can get in touch through this address...astypalea@gmx.com. I hope you still have the lathe.
regards !
We can get in touch through this address...astypalea@gmx.com. I hope you still have the lathe.
regards !