Wanted - Computer/Control mounting arm for Triac/Cyclone

Anything to do with buying, selling or sourcing Denford machines, spares or software - please use sensibly!

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
moray
CNC Apprentice
CNC Apprentice
Posts: 69
Joined: Thu 12 Sep , 2013 20:02 pm
Hardware/Software: Cyclone TU150E (Running KMotionCNC with Servos)
Novamill running V5
Triac VMC

Wanted - Computer/Control mounting arm for Triac/Cyclone

Post by moray » Sun 03 Dec , 2017 22:50 pm

I'm looking for the mounting bracket/arm as used on Triacs and Cyclones (plus I'm sure other machines), as per the photos attached.
Attachments
IMAG0277_crop.jpg
IMAG0277_crop.jpg (273.3 KiB) Viewed 315 times
IMAG0276_crop.jpg
IMAG0276_crop.jpg (236.2 KiB) Viewed 315 times

jamesgates1000
CNC Apprentice
CNC Apprentice
Posts: 58
Joined: Sat 01 Aug , 2015 9:23 am
Hardware/Software: 2001 Cyclone with toolchanger and Fanuc 21i control
Serial number - H00913.
Voltage 415V F.L.C 20A 50Hz 3Ph

1997 Triac VMCwith toolchanger and Fanuc O-M control
Serial number - 70826B.
Voltage 415V F.L.C 30A 50Hz 3Ph

Re: Wanted - Computer/Control mounting arm for Triac/Cyclone

Post by jamesgates1000 » Fri 15 Dec , 2017 0:14 am

I have some large lumps of steel and one to. Take measurements from. I could make one up for you. What happened to yours?

moray
CNC Apprentice
CNC Apprentice
Posts: 69
Joined: Thu 12 Sep , 2013 20:02 pm
Hardware/Software: Cyclone TU150E (Running KMotionCNC with Servos)
Novamill running V5
Triac VMC

Re: Wanted - Computer/Control mounting arm for Triac/Cyclone

Post by moray » Fri 15 Dec , 2017 0:54 am

My Cyclone never came with one, and now that I've nearly got a new control panel made for the Triac, I'd quite like to make one for the Cyclone, rather than just have a computer sat on top.

I can make one, but I was hoping somebody would have one lying around to save me the hassle.

Post Reply