Can you set different origins in terms of where the laser starts without moving the object/drawing in the original laserCam software. Currently I can only get it starting from the lower left corner
Can you change where the laser starts cutting in LaserCAM ?
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Can you change where the laser starts cutting in LaserCAM ?
Recent question from a customer using LaserCAM 2D with a versalaser laser cutter:
-
Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
If you notice when you go to the print preview in LaserCAM, there are two boxes called offset (mm) X and Y.
Setting these values will offset the print output, but not alter the original drawing
See this image...
Setting these values will offset the print output, but not alter the original drawing
See this image...
- Attachments
-
- Offset the print output in LaserCAM and QuickCAM
- lasercam-offset-printing.gif (23.56 KiB) Viewed 4515 times