Denford Software & Machines

Denford Software & Machines

  
 

Denford Software & Machines

Welcome to the Denford CAD CAM CNC forum


Hint - Try the google search at the bottom of the page
It is currently Sat 25 May , 2013 15:45 pm

View unanswered posts | View active topics


Board index » CAD / CAM Software » QuickCAM / LaserCAM 2D Design

All times are UTC [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Denford Admin
 Post subject: Can you change where the laser starts cutting in LaserCAM ?
PostPosted: Fri 24 Nov , 2006 10:21 am 
Offline
Site Admin
User avatar

Joined: Fri 10 Feb , 2006 12:40 pm
Posts: 3486
Location: Sunny Brighouse Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Recent question from a customer using LaserCAM 2D with a versalaser laser cutter:

Quote:
Can you set different origins in terms of where the laser starts without moving the object/drawing in the original laserCam software. Currently I can only get it starting from the lower left corner
Top
 Profile  
 
Denford Admin
 Post subject:
PostPosted: Fri 24 Nov , 2006 10:39 am 
Offline
Site Admin
User avatar

Joined: Fri 10 Feb , 2006 12:40 pm
Posts: 3486
Location: Sunny Brighouse Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
If you notice when you go to the print preview in LaserCAM, there are two boxes called offset (mm) X and Y.

Setting these values will offset the print output, but not alter the original drawing

See this image...


Attachments:
File comment: Offset the print output in LaserCAM and QuickCAM
lasercam-offset-printing.gif
lasercam-offset-printing.gif [ 23.56 KiB | Viewed 1884 times ]
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » CAD / CAM Software » QuickCAM / LaserCAM 2D Design

All times are UTC [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Template made by DEVPPL
[ Time : 0.157s | 19 Queries | GZIP : Off ]
 
Loading