LaserCAM problem: "Floating point"

A forum for anything to do with QuickCAM 2D Design and LaserCAM 2D Design. Submit advice, examples, problems, feature requests etc..

Moderators: Martin, Steve, Mr Magoo

Post Reply
rob_can
Posts: 1
Joined: Mon 27 Jan , 2014 15:42 pm
Hardware/Software: LaserCAM 2D Design

LaserCAM problem: "Floating point"

Post by rob_can » Mon 27 Jan , 2014 16:45 pm

I'm experiencing a problem with LaserCAM 2D Design v1.15.5.361 on Windows 7 64-bit HP desktop PCs. I have a classroom of about 20 of them, and the problem seems to randomly occur; that is to say that it is not limited to particular computers or users.

Symptom: When attempting to change a line colour from etch (blue) to cut (red) or visa-versa the program throws an error that reads "Floating point". The colour-changing buttons then stop responding until I restart the program.

Has anyone else had this problem, or have a solution?

Post Reply