Access violation at address 014B57F4 in module VECAD.dll

A forum for anything to do with QuickCAM 2D Design and LaserCAM 2D Design. Submit advice, examples, problems, feature requests etc..

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Access violation at address 014B57F4 in module VECAD.dll

Post by Denford Admin » Tue 26 Feb , 2008 10:35 am

I get:

Code: Select all

Access violation at address 014B57F4 in module 'VECAD.dll'. Read of address 00000000.
whenever I try to export a .dxf file from QuickCAM or LaserCAM

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Tue 26 Feb , 2008 10:37 am

Unfortunately, there is a bug in the DXF engine in both QuickCAM and LaserCAM and we are unable to do anything about it :cry:

The problem only appears the very first time you try to create a dxf file. Try again and the dxf file will be created properly
:)

Post Reply