LaserCAM and QuickCAM 2D v1.6 released 19th June 2007

A forum for anything to do with QuickCAM 2D Design and LaserCAM 2D Design. Submit advice, examples, problems, feature requests etc..

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

LaserCAM and QuickCAM 2D v1.6 released 19th June 2007

Post by Denford Admin » Tue 19 Jun , 2007 16:02 pm

Last edited by Denford Admin on Tue 19 Jun , 2007 17:01 pm, edited 2 times in total.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Tue 19 Jun , 2007 16:03 pm

Notes on v1.6:

added Quickcam version info into the post output as a comment

more fonts added to the install

fixed the problem where clicking on the select arrow again, would stop you from doing a rectangle select (froze up the select in the cad window)

fixed problems where arcs/circles/rectangles would revert back to original orrientation if grouped, then mirrored

added make/break group to the popup menu

added Plunge Feed Percentage=25 into post processor file to speed up plunging in some machines/materials

fixed open-with file (double clicking an mcm file) which had stopped working

put minimum widths on the toolbars (you could make zero width when floated)

Post Reply