QuickCAM 2D v2.6 and LaserCAM 2D v2.6 released 21st Jun 2018

A forum for anything to do with QuickCAM 2D Design and LaserCAM 2D Design. Submit advice, examples, problems, feature requests etc..

Moderators: Mr Magoo, Martin, bradders, Steve

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3587
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

QuickCAM 2D v2.6 and LaserCAM 2D v2.6 released 21st Jun 2018

Post by Denford Admin » Thu 21 Jun , 2018 12:38 pm

QuickCAM 2D v2.6 and LaserCAM 2D v2.6 released 21st Jun 2018

There is an option on the CAM options list called 'Always Retract'. This always retracts the tool when moving from one path to the next, regardless of the distance between the two. With it switched off, the tool won't retract if the distance is less than the diameter of the tool.

There is a fixed debug message that would be shown when importing a DXF file.


As usual - check here for the latest version:
http:/http://website.denford.ltd.uk/software- ... s-support/

Post Reply