Search found 5 matches

by Jimmy_Arnott
Fri 18 Nov , 2016 9:44 am
Forum: Software
Topic: Starmill Setup Help
Replies: 10
Views: 10941

Re: Starmill Setup Help

There is a massive manual in a binder which says on the front page Version 2.69, and when trying to install software from the floppies inside Windows 3.1 it says it's a DOS based application only, I'm not competent enough with DOS to know how to run the software, the command for installing the softw...
by Jimmy_Arnott
Thu 17 Nov , 2016 17:52 pm
Forum: Software
Topic: Starmill Setup Help
Replies: 10
Views: 10941

Re: Starmill Setup Help

Hi, sorry for the late reply I didn't have any time at school yesterday to work on this so I got in today, searched around a bit and managed to find all the original documentation, student help guides, AND all the software. There seems to be two versions of the software, one set is on floppies which...
by Jimmy_Arnott
Tue 15 Nov , 2016 17:02 pm
Forum: Software
Topic: Starmill Setup Help
Replies: 10
Views: 10941

Re: Starmill Setup Help

Thank you for your responses, I managed to find this box and with the help of one of the technicians moved it to where the mill is, tomorrow I will hopefully have time to try and clean out the unit and see if it will run :D
by Jimmy_Arnott
Tue 15 Nov , 2016 12:02 pm
Forum: Software
Topic: Starmill Setup Help
Replies: 10
Views: 10941

Re: Starmill Setup Help

Ahhhhh, this makes a bit more sense, I managed to find the desktop tutor box and I thought there must be some part I'm missing, i'll go have a hunt around the department for this but I don't know if it was supplied with the unit, I would imagine these by themselves are quite expensive?
by Jimmy_Arnott
Mon 14 Nov , 2016 10:23 am
Forum: Software
Topic: Starmill Setup Help
Replies: 10
Views: 10941

Starmill Setup Help

Hi, long story reasonably short I am an A level student and my school has an old Starmill CNC milling machine which has been sat on a table for the best part of a decade. (Picture attached) My question is first does anyone know the pin out for the connector shown in my second attached picture? It is...