Search found 6 matches

by PROFGREEN
Mon 11 Jan , 2016 16:00 pm
Forum: VersaLaser
Topic: Renewing Laser Cartridge
Replies: 2
Views: 2558

Re: Renewing Laser Cartridge

Yeah,

Just dropped 'em an email about it, see what they come up with?

Thanks Bradders.

Graham.
by PROFGREEN
Wed 06 Jan , 2016 10:29 am
Forum: VersaLaser
Topic: Renewing Laser Cartridge
Replies: 2
Views: 2558

Renewing Laser Cartridge

Hello again gents, As a follow up to my previous posts I am now experiencing very much the same symptoms as before!! Beam is aligned etc etc but cutting is painful to observe across the entire bed!! Methinks it's time for a replacement laser cartridge. Could you advise on a price and if I am able to...
by PROFGREEN
Tue 13 Oct , 2015 10:28 am
Forum: VersaLaser
Topic: INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABLE
Replies: 5
Views: 2773

Re: INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABL

I am adjusting the first mirror housing (on the left) taken the part cover off, 2 small crosshead screws, and can get to the three screws of the housing. Re-aligned beam using three Allen screws.
Just put all the parts back-BINGO Brand new machine!
Superb !

Cheers fella
by PROFGREEN
Tue 13 Oct , 2015 9:10 am
Forum: VersaLaser
Topic: INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABLE
Replies: 5
Views: 2773

Re: INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABL

Martin,
The beam alignment is way out!!!
How do I remove and re-install the laser cartridge please?
Cheers
G
by PROFGREEN
Tue 06 Oct , 2015 14:47 pm
Forum: VersaLaser
Topic: INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABLE
Replies: 5
Views: 2773

Re: INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABL

Thanks Martin, I will check the beam alignment and let you know!
by PROFGREEN
Tue 06 Oct , 2015 11:18 am
Forum: VersaLaser
Topic: INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABLE
Replies: 5
Views: 2773

INCONSISTANT VECTORING/CUTTING ACROSS THE LENGTH OF TABLE

Please can you help? My machine is not cutting or rastering consistently. It is fine to the left side of the table, but when asked to do a job that fills the bed, cutting is no where near going through material (3mm acrylic) and etching/rastering is barely visible to the right and lower parts of the...