Hi,

Bit of a long shot but do you still have any of the boards for sale?

Thanks, Oliver

Hi all, I was wondering if someone could help me. I recently acquired a Denford Easimill 1984 model which is missing all its stepper motors. I was wondering if someone could tell me what frame size the stepper motors are i.e. Nema 34 or 42? Also what holding torque they are? I have been looking on t...

Hi, I recently purchased an Easiturn 3 lathe which is missing its 3 phase motor. Not sure why it was taken off but need to get a replacement. I was hoping someone could help me with the following; 1.What is the speed that the motor is rated at? I know it is 240v 3ph, but unsure of the speed? Would a...

Hi,
I was wondering if anyone could point me in the right direction were I could find a replacement nut for the x axis lead screw? Basically the two U shaped pins have worn threw and need replacing.

Or if anyone has one they would like to sell?

Any help would be appreciated.

Best regards,
Oliver

Thank you for your help so far CNC Guru. I’m finally getting some were now. I have found that one of the driver boards have failed and have been pulling the 24v supply voltage to both drivers down. Once I had removed the faulty board on the Y axis the board on the X now works fine. Two problems I’m ...

Hi,

I was wondering if anyone has a Parker / Digiplan CD20 driver board for sale?

If you do could you email me at; oliverjenner@hotmail.com

Many thanks,
Oliver

The steppers don’t appear to be locking up and the multi-way block is connected. Could you tell me what voltage I should expect at the multi way block for the steppers? I have traced the 24v terminal from the stepper drivers back to the supply regulation board PC1601. I have 24vac coming in to the b...

Thank you for the reply CNC Guru but I’m afraid that I have tried that. It will not work in ether in manual or when I program it with a tool path. Could anyone tell me what voltage CD20 stepper drivers require? I have 58v going to them but from looking at the CD20 user manual on this site there is m...

Hello everyone, I recently purchased an Orac lathe and I’m having difficulty getting it to work correctly. The issue I’m having is that it is not moving in ether the X or Y direction but everything else is working including the spindle speed control. I have checked the fuses located at the back of t...