Search found 6 matches

by hedmunds
Wed 25 Jul , 2018 5:46 am
Forum: Router 2600
Topic: x axis slipping during cut
Replies: 12
Views: 14684

Re: x axis slipping during cut

Hi again, Some personal stuff came up so I've been away the last two months. I've tried doing what you said withe nuts on the x axis. I've also pulled out those 3/4 Plastic guides and cleaned them. I tried running them on the rails before I put them back into the y frame and they were running smooth...
by hedmunds
Tue 22 May , 2018 7:10 am
Forum: Router 2600
Topic: x axis slipping during cut
Replies: 12
Views: 14684

Re: x axis slipping during cut

Thanks for your reply. When I cleaned the nuts on the x axis I did check to see if it slid easily and provided that I was pushing evenly across the two rails it did slide easily. I've notice that it only happens when it is at least 400 mm away from the home on the x axis. I've had some stuff that ne...
by hedmunds
Mon 21 May , 2018 7:48 am
Forum: Router 2600
Topic: x axis slipping during cut
Replies: 12
Views: 14684

Re: x axis slipping during cut

Thanks for your respond. I tried that, it worked for a day and then the same problem came back. So I stripped the nuts again and cleaned them again and it's still doing it. I checked that the nuts were in the correct orientation when I put them back on but I am going to double check when I'm in next...
by hedmunds
Mon 07 May , 2018 7:40 am
Forum: Router 2600
Topic: x axis slipping during cut
Replies: 12
Views: 14684

x axis slipping during cut

Hi, We have a router 2600 Pro which has worked fine for many years now. I started it up this morning and did a few cuts and it was working fine. The forth cut I did came out as if the x offset had moved 50mm half way through the cut, half the design was in the right location and the other half had m...
by hedmunds
Fri 05 Aug , 2011 6:42 am
Forum: Router 2600
Topic: spindle speed issues
Replies: 1
Views: 7122

spindle speed issues

I now have spindle speed but it is way too slow. On the vr milling software it says it is spinning at 24000 AND 120% but it is not. I have turned up the spindle spped dial on the denford router and it is working according to the vr milling readout. It seems to start spinning at about 12000 rpm and t...
by hedmunds
Mon 04 Jul , 2011 7:43 am
Forum: Router 2600
Topic: no spindle speed on router
Replies: 5
Views: 6642

no spindle speed on router

Problem: I have just turned on my machine and everything seems fine but no spindle speed. When I try to operate manual spindle still no go. On the codes it goes over the line but seems to lock the door and stop on the code. fuses look ok. Lead up to problem: no issues were evident in the lead up. Ma...