Quite true! Could you by any chance supply a replacement tube (just the tube, the needle valve & fittings are fine)?

Just a little cautionary tale! Recently,despite regular reminders, one of our students used our VL300 without switching on the extraction cart, resulting in a badly burnt lens. I ordered and fitted a new one without any problem, but after a short time the machine stopped cutting. I looked at the len...

Will do!

Cartridge changed, works fine now, thanks Bradders!

Thanks Bradders, air assist cone is clear and aligned, so it looks like the laser is on its way out. Ho hum I'd better get on the phone then...

Cheers

Chris V.

I'm using a 7 year old VL300 & have started to have problems cutting through acetate. The optics are clean and blemish free, the focussing is good & the correct material and thickness have been selected, but the laser is only cutting about 3/4 of the way through. I've tried increasing the intensity,...

One thing you could try. We had a similar problem and when I opened up the compressor unit I found that the DIP switch block had fallen off the small circuit board. Re-soldered it in place & hey presto, it works fine.

Finally got the boss to tell me what he was up to - it was him who asked me to post the original question. All he's doing is importing photographs from Corel to produce lithophanes, so there should be no problems there. Isn't it easier when you know what someone is trying to do???

You're right, a slight mental aberration on my part!

Hi, we are running versalaser software VLS 1.29.1 & are thinking of upgrading to Corel Draw X4, are the two compatible?

Thanks

Chris V.

Does anyone know if Quickcam Pro v1.9 is compatible with Corel Draw X4, as we are thinking of upgrading?

Thanks in advance

Chris Vaudin